NeoNail LED lamp 18W/36 LCD display 1 piece

NeoNail LED lamp 18W/36 LCD display 1 piece

Permanent, full of shine, resistant to damage - you can make such hybrid stylizations using a 18W / 36W LED lamp. 3 operating modes - the lamp has 3 times: 30s, 60s and 99s. You can adjust each of the modes to your needs and the type of manicure you are performing. Low Heat Mode - this system is responsible for the gradual heating of the lamp. The increase in power occurs first after 30s, and then after 50s. The mode reduces the burning sensation of the plate, especially when curing gel stylizations. Motion sensor/display - no need to set working time. An additional option is the motion sensor - as soon as you put your hand under the lamp, it will start for a maximum of 99 seconds. When removed, the device will turn off. The curing time is shown on the digital display. When selecting one of the operating modes, the time remaining until the end of exposure appears. The lamp has 21 LEDs, they are evenly spaced, thanks to which they properly harden the hybrid or gel on each nail. The large, streamlined shape of the lamp allows you to fix the entire hand styling at the same time. The device does not have an attached bottom, which is easier when creating pedicure .

Technical data:

21 LEDs, Power: 18W, Voltage: DC 12V, 2A,

Dimensions: 215x133x75mm,

Wavelength: 365+405nm.

LED lifetime: 50,000 h

User manual,

Warranty Card.

HOW TO USE

1. Connect the lamp to the power adapter.

2. After starting the device, select the lamp working time using the Timer 30s, 60s or 99s. Pressing the Low Heat Mode button will slowly heat up the device. This mode is especially helpful in case of problems with varnish curing.

3. If the Timer buttons are not used, the infrared sensor will start working when you put your hand into the lamp. If the lamp is started using a motion sensor, the active working time counter will be displayed. The maximum working time without starting the Timer is 99s.

4. The device will turn off when we extend our hand.

5 . After selecting the Timer mode, the display will show the time remaining until the end of exposure.